top of page

Renovating Your Pool in Flower Mound? Don't Stop at the Water

Nov 11
4 min read

Most pool renovation calls start with the water. The plaster is rough, the tile line is stained, the pump sounds like it's on its last legs. Those are real problems, and they're a pool company's job. But when I walk out back, the pool is rarely the only thing that's tired.


There's a crack running across the deck, the beds are full of shrubs dropping leaves into the skimmer, and a sprinkler head is soaking the concrete every morning.

That's especially true in Flower Mound.


The average house here is close to 30 years old, and if the pool went in with the house, the deck, the beds and the sprinkler zones around it are just as old. Most of them have never been redone. If the pool is getting torn up anyway, that's the time to fix everything around it too.


Why Late Fall and Winter Are the Time to Start


Nobody is swimming in December, so a backyard can be torn up for a few weeks without costing you a single pool day. Pool and outdoor crews also have more room on their schedules now than they will in April, when everybody wants it done by summer. Start now and the whole project can be finished before swim season.


It's the right time for the planting side, too. Shrubs and perennials planted in late fall and winter spend the cool months growing roots, so they head into their first July ready for the heat instead of fighting it.


The Deck Is Usually the First Thing to Go


Flower Mound sits on heavy clay that swells when it gets wet and shrinks when it dries out. A pool deck rides on top of that clay, so every wet spring and dry August pushes it around a little. Over 20 or 30 years that adds up to cracks, low spots that hold water, and sections that have lifted or dropped away from the pool.


The pool and the deck are built as two separate pieces so they can move independently. The joint between them is supposed to stay sealed. When that sealant cracks or pulls loose, water runs straight under the deck and makes the movement worse. If yours looks dried out or gapped, deal with it first.


When a deck is too far gone to patch, here's how I think about replacing it:


  1. Pavers flex where concrete cracks. Individual pavers shift a little with the soil instead of cracking, and a section that settles can be pulled up and reset.

  2. If you stay with concrete, ask about joint spacing. Control joints give a slab a planned place to crack. On our clay, closer spacing matters. Every 8 to 10 feet is a good target.

  3. Go light in color. Dark pavers and stone get too hot to walk on barefoot by July.


Your Sprinklers Might Be Part of the Problem


This is the part most pool renovations miss. On clay, the goal is soil that stays evenly moist: not soaked, not bone dry. A lot of older pool yards get that backwards. The zone next to the deck runs too long, a head is aimed right at the concrete, and the gutters drain toward the pool. All of that water ends up under the deck.


Here's what I look for when I walk a pool yard:


  1. Heads set right against the deck. A sprinkler tight against the edge can wash out the sand bed under the deck over time, and then the deck starts to move. Those heads need to be pulled back or swapped out.

  2. Overspray into the pool. Sprinkler water carries lawn and bed fertilizer with it. In the pool, fertilizer makes your chemicals work harder and can stain the surface.

  3. Water draining toward the deck. If runoff from the yard or a downspout heads toward the pool, it needs to be sent somewhere else.


For beds right next to a pool, I usually recommend switching them to drip. It puts water at the roots, nothing sprays onto the deck or into the water, and it keeps the soil far more even. If you just want your current system checked, our sprinkler repair crew can find the heads and zones that are doing the damage.


You can see everything else we handle on our sprinkler and irrigation page.


Plants That Belong Next to a Pool


Anything planted within a few feet of the water ends up in it eventually. Leaves, petals, berries and seed heads all head straight for the skimmer basket. The deck also throws a lot of heat back at whatever is planted beside it. So the rule next to a pool is simple: pick plants that handle reflected heat and hold onto their stuff.


  1. Good near the water: small-leaf evergreens like dwarf yaupon holly, and tough natives like red yucca that barely shed.

  2. Keep back from the edge: anything with a sharp tip, like agave, belongs well away from walkways and wet feet.

  3. Skip right next to the pool: crape myrtles, which drop blooms all summer, and big shade trees whose leaves and roots don't belong near the shell or the plumbing.


North Texas clay narrows the list even more. I covered which plants hold up in it in best plants for Flower Mound's clay soil.


Where to Start


You don't have to do all of this at once, but it's a lot cheaper to plan it at once. If a pool company is redoing the water side, get us out early so the deck, sprinklers and beds are planned around their schedule instead of after it. And if the work touches the fence or gate around your pool, Flower Mound has specific rules for pool barriers, so we check those before anything comes down.


Our outdoor living and hardscape crew handles the deck and the beds, and we can fix the sprinklers in the same visit. If you're in Flower Mound or nearby, get a quote and I'll come take a look before the weather warms up.




Rob Dilts

Owner

RD Services


Comments


Commenting on this post isn't available anymore. Contact the site owner for more info.

©2025 by RD Services. Proudly created with Wix.com

  • Instagram
  • Facebook
bottom of page